Multi-Setpoint Controller - Pixsys Electronics ATR142


Controller 32x74mm, single control loop, 3 setpoints. Distinctive feature is the high configurability resulting in single ordering code (the only optional feature not included in basic code is the serial communication RS485-ModbusRTU Master/Slave) as well as the extended supply range 24....230Vac/dc, galvanically isolated and not requiring any jumpers selection.

Universal analogue input selectable for a wide range of sensors. Relay/SSR outputs programmable at software level as command , alarm/event.

User-friendly operation, programming tools for quick set-up (MEMORY-CARD, programming and monitoring software LABSOFTVIEW).

Multi-Setpoint Controller, Pixsys Electronics, ATR142


Box: 32x74 (front panel) x 53 mm
Power supply: 24...230Vac/dc ±15% 50/60 Hz
Consumption: 2 W
Display: 4 digits 0,4" green + 4 digits 0,3" red + 6 signaling leds
Operating conditions: Temperature 0-45 °C, humidity 35..95 RH%
Material: Box: Noryl UL94V1 self-extinguishing; front panel: PC ABS UL94V0 self-extinguishing
Weight: Approx. 112 g
Sealing: Front panel IP65 (with gasket) , Box IP30, Terminal bloks IP20
Quick set-up options: Memory Card with / without battery, software LABSOFTVIEW, EASY-UP codes


1 configurable: Selection TC, K, J, S, R, PT100,PT500, PT1000, Ni100, PTC1K, NTC10K (B 3435K), 0/4..20 mA, 0..10 V, 0...40mV, Potentiometer 1...6/160 Kohm.

Sampling time: 4,1 ms (Frequency 242 Hz)

1 digital input: 1/2 setpoint selection, Hold, Run (only if TC, 0...10V, 0/4...20mA, 0...40mV)


2 Relays: 1 Relay 8A - 250 Vac resistive charge + 1 Relay 5A - 250 Vac resistive charge

1 SSR: 12 Vdc - 30 mA

Serial communication: RS485 Modbus RTU - Master/Slave


Site Designed And Maintained By Panther Marketing And Design